Terminal Strip; Figure 2.9 - Typical Terminal Strip Connections - Reliance electric GV3000/SE Hardware Reference, Installation, And Troubleshooting Manual

2.6.2 Terminal Strip

Encoder
Feedback and
15 VDC Supply
0 to 10 VDC Meter
or Other Device
Reference Potentiometer
Use with Digital Inputs 1-8
When Externally Powered
2.6.3 RS-232 Communication Port
2-10
The terminal strip on the Regulator board provides terminals for connecting customer
I/O devices. See figures 2.6 and 2.9. The following terminals are provided:
•
Terminals 4-9: Encoder connections
•
Terminals 10-11: Analog output connections
•
Terminals 12-15: Analog speed/torque reference connections
•
Terminals 16-25: 24V DC digital input connections
Digital Inputs
(6, 7, and 8 are
Software-Assignable)
Figure 2.9 – Typical Terminal Strip Connections
The Regulator board contains a 9-pin D-shell RS-232 communication port (X8). See
figure 2.6. This port provides RS-232 communication between the GV3000/SE drive
and a personal computer running the Control and Configuration (CS3000) Software.
Refer to instruction manual D2-3348 for more information about the CS3000 software.
4
+ 1 5 V D C
5 Phase A
6
Phase A Not
7
Phase B
8
Phase B Not
9 Regulator Common
1 0 0 to 10 VDC Analog Output
1 1
Analog Output Return
1 2
Isolated Reference Voltage
1 3
+/- 10, 0 to 10 VDC Speed or Torque Reference
1 4 0/4 to 20 mA Speed or Torque Reference
1 5 Isolated Reference Ground
1 6 +24 VDC Supply
1 7
Digital Input 8 (Local/Remote)
1 8
Digital Input 7 (Ramp 1/ Ramp 2)
1 9
Digital Input 6 (Forward/Reverse)
2 0
Digital Input 5 (Function Loss)
2 1
Digital Input 4 (Run/Jog)
2 2
Digital Input 3 (Fault Reset)
2 3
Digital Input 2 (Stop)
2 4
Digital Input 1 (Start)
2 5
+ 2 4 V D C C o m m o n
GV3000/SE AC Bookshelf Drive Hardware Reference, Version 6.06