Trigger.timer[N].Clear() - Keithley 2600B Reference Manual

Section 7: TSP command reference

trigger.timer[N].clear()

This function clears the timer event detector and overrun indicator for the specified trigger timer number.
Type TSP-Link accessible
Function Yes
Usage
trigger.timer[N].clear()
N
Details
This command sets the timer event detector to the undetected state and resets the overrun indicator.
Example
trigger.timer[1].clear()
Also see
trigger.timer[N].count
trigger.timer[N].count
This attribute sets the number of events to generate each time the timer generates a trigger event.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
count = trigger.timer[N].count
trigger.timer[N].count = count
count
N
Details
If count is set to a number greater than 1, the timer automatically starts the next delay at the
expiration of the previous delay.
Set count to zero (0) to cause the timer to generate trigger events indefinitely.
Example
print(trigger.timer[1].count)
Also see
trigger.timer[N].clear()
trigger.timer[N].reset()
7-374
Series 2600B System SourceMeter® Instrument Reference Manual
Affected by
Trigger timer number (1 to 8)
(on page 7-374)
Affected by
Instrument reset
Recall setup
Trigger timer N reset
Number of times to repeat the trigger (0 to 1,048,575)
Trigger timer number (1 to 8)
(on page 7-374)
(on page 7-378)
Where saved Default value
Clears trigger timer 1.
Where saved Default value
Not saved 1
Read trigger count for timer number 1.
2600BS-901-01 Rev. C / August 2016