Specifications - Emerson Rosemount Oxymitter 4000 Instruction Manual

Oxymitter 4000

SPECIFICATIONS

1-16
Oxymitter Specifications
O Range
2
Standard
Accuracy
System Response to Calibration
Gas
Temperature Limits
Process
Electronics Housing
Electronics Package
Local Operator Interface
Probe Lengths
Mounting and Mounting Position
Materials
Probe
Electronics Enclosure
Calibration
Calibration Gas Mixtures
Recommended
Calibration Gas Flow
Reference Air
Electronics
Electric Noise
Certifications
Line Voltage
0 to 10% O , 0 to 25% O
2
±0.75% of reading or 0.05% O
Initial – less than 3 seconds, T90 – less than 8
seconds
32°to 1300°F (0° to 704°C) up to 2400°F (1300°C)
with optional accessories
-40° to 158°F (-40°to 70°C) amb ient
-40° to 185°F (-40°to 85°C) [Operating temperature
of electronics inside of instrument housing, as
measured by a HART communicator, Rosemount
Asset Management Solutions software.]
-40°to 158°F (-40°to 70° C), [above 158°F (70°C) the
infrared keypad will cease to function, but the
Oxymitter 4000 will continue to operate properly.]
18 in. (457 mm)
3 ft (0,91 m)
6 ft (1,83 m)
9 ft (2,74 m)
Vertical or horizontal;
a spool piece, (P/N 3D39761G02), is available to
offset transmitter housing from hot ductwork.
Wetted or welded parts - 316L stainless steel (SS)
Non-wetted parts - 304 SS, low-copper aluminum
Low-copper aluminum
Manual, semi-automatic, or automatic
0.4% O , Balance N
2 2
8% O , Balance N
2 2
2.5 l/min (5 scfh)
1 l/min (2 scfh), clean, dry, instrument-quality air
(20.95% O ), regulated to 34 kPa (5 psi)
2
NEMA 4X, IP66 with fitting and pipe on reference
exhaust port to clear dry atmosphere
EN 61326-1, Class A
General Purpose
90-250 VAC, 48/62 Hz. No configuration necessary.
3/4 in. -14 NPT conduit port
Table continued on next page
Instruction Manual
IM-106-340, Rev. 4.3
July 2017
, 0 to 40% O (via HART)
2 2
, whichever is greater
2
12 ft (3,66 m)
15 ft (4,57 m)
18 ft (5,49 m)