thomann SePar QUAD LED RGB UV IR User Manual page 38

Operating
Colour mode (SePar Quad RGB
UV IR)
Sound mode
38
Press [Mode] or [Up] | [Down] until the display shows 'CLor' . All LEDs now light up at full inten‐
sity. Press [Setup]and then use [Up] | [Down] to set the intensity of the red colour between
'r000' (off) and 'r255' (full). Press [Setup]and then use [Up] | [Down] to set the intensity of the
green colour between 'g000' (off) and 'g255' (full). Press [Setup]and then use [Up] | [Down] to
set the intensity of the blue colour between 'b000' (off) and 'b255' (full). Press [Setup]and then
use [Up] | [Down] to set the intensity of the UV ranger between 'u000' (off) and 'u255' (full).
A constant colour can only be activated when the unit is operating in stand-alone mode or as
master in a master / slave combination. This setting takes effect only when the device is not
operated under DMX control.
Press [Mode] or [Up] | [Down] until the display shows 'SoUn' The device now shows a music-
controlled colour sequence. Press [Setup]and then use [Up] | [Down] to set the sensitivity of the
built-in microphone for the music control between 'SU00' (low) and 'SU31' (high).
LED-PAR