thomann SePar QUAD LED RGB UV IR User Manual page 37

Slave mode
Colour mode (SePar Quad RGBW
IR)
Press [Mode] or [Up] | [Down] until the display shows 'SLAv' . The device is now operating in
slave mode, i.e. with correct wiring it will behave exactly like the controlling master device.
This setting takes effect only when the device is not operated under DMX control.
Press [Mode] or [Up] | [Down] until the display shows 'CLor' . All LEDs now light up at full inten‐
sity. Press [Setup]and then use [Up] | [Down] to set the intensity of the red colour between
'r000' (off) and 'r255' (full). Press [Setup]and then use [Up] | [Down] to set the intensity of the
green colour between 'g000' (off) and 'g255' (full). Press [Setup]and then use [Up] | [Down] to
set the intensity of the blue colour between 'b000' (off) and 'b255' (full). Press [Setup]and then
use [Up] | [Down] to set the intensity of the white colour between 'w000' (off) and 'w255' (full).
A constant colour can only be activated when the unit is operating in stand-alone mode or as
master in a master / slave combination. This setting takes effect only when the device is not
operated under DMX control.
SePar QUAD LED RGB UV IR, SePar QUAD LED RGBW
Operating
37