thomann SePar QUAD LED RGB UV IR User Manual page 36

Operating
Program mode
DMX address
36
Press [Mode] or [Up] | [Down] until the display shows 'Pro' . Press [Setup]and then use [Up] |
[Down] to select one of the programs between 'Pr01' to 'Pr12' .
A preprogrammed automatic show can only be activated when the unit is operating in stand-
alone mode or as master in a master / slave combination. This setting takes effect only when
the device is not operated under DMX control.
If you select 'Pr01' , you can press [Setup] and then use [Up] | [Down] to select 15 pre-pro‐
grammed colour patterns, which will then light up constantly. Or select '-OFF' to activate
Blackout. Press [Setup] and then use [Up] | [Down] to set a flashing speed between 'FS01' (slow)
and 'FS99' (fast) or 'FSFL' (strobe effect). For constant light, select 'FS00' .
Programs 'Pr02' ‑ 'Pr12' provide pre-programmed colour sequences. After selecting a pro‐
gram, press [Setup]and then use [Up] | [Down] to set the speed of the colour sequences
between 'SP01' (slow) and 'SPFL' (fast). Press [Setup] and then use [Up] | [Down] to choose a
flashing speed between 'FS01' (slow) and 'FS99' (fast).
Press [Mode] or [Up] | [Down] until the display shows 'd---' . Press [Setup]and then use [Up] |
[Down] to set the desired DMX address between 1 and 512 (display 'd001' ... 'd512' ). Make sure
this number matches the configuration of your DMX controller.
This setting is only relevant if the device is being controlled via DMX.
Press [Setup]and then use [Up] | [Down] to select the DMX mode (2, 4, 6 or 8 channels).
LED-PAR