Operating Controls On The Device - thomann SePar QUAD LED RGB UV IR User Manual

7.3 Operating controls on the device

Auto mode
Press [Mode]to activate the main menu. Press [Mode]again to access additional menu items. To
activate the displayed menu item, press [Setup]. Use [Up] and [Down]to change the respec‐
tively displayed value. Changed values and settings will be applied immediately. Use [Mode] to
return to the previous menu level.
If you do not press any button for about 15 seconds the display turns off. The set values are
retained even when the device is disconnected from the mains power supply.
Press [Mode] repeatedly until the display shows 'AUTO' . The device now operates in automatic
stand-alone mode.
Automatic operation can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting takes effect only when the device is not
operated under DMX control.
Press [Setup]and then use [Up] | [Down] to set a program speed between 'SP01' (slow) and
'SPFL' (fast). Press [Setup] and then use [Up] | [Down] to set a flashing speed between 'FS01'
(slow) and 'FS99' (fast). Press [Setup] and then use [Up] | [Down] to set a switching speed
between 'n001' (slow) and 'n100' (fast).
SePar QUAD LED RGB UV IR, SePar QUAD LED RGBW
Operating
35