Table of Contents
Advertisement
12
Install the compression nut onto the hose.
13
Thread the compression fitting over the hose barb, counter-clockwise,
until it is flush or slightly lower than the hose barb.
The compression fitting is reverse threaded.
Apply DOT grease to the outside of the compression fitting and the
threads of the compression nut.
14
Install the compression fitting and nut into the lever.
15
Tighten the compression nut.
Clean the lever.
Slide the hose boot onto the compression nut.
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions,
This concludes the Guide Ultimate™ Brake Service.
8 mm Flare Nut
⚠ CAUTION
visit
www.sram.com/service.
DOT Grease
8 N·m (71 in-lbs)
Lever Blade Installation
29
Advertisement
Table of Contents
