SRAM Guide Ultimate Service Manual page 13

4 Align the caliper body halves then use a T25 TORX
each body bolt into the caliper two full turns.
Install the heat shield.
5 Use a T25 TORX bit socket with a torque wrench to tighten each bolt
to 4.4-5.4 N·m (39-48 in-lb).
6 Remove the o-rings from the banjo bolt and banjo fitting.
Apply a small amount of SRAM® High-Performance 5.1 DOT fluid to the
new o-rings and install them.
®
wrench to thread
T25 TORX
T25 TORX
20 mm or 15 mm Thru Axle
4.4-5.4 N·m (39-48 in-lb)
Caliper Piston Installation 13