SRAM Guide Ultimate Service Manual page 20

4 Remove the SwingLink™ bushings by hand.
5
Insert the SRAM® Guide Lever Internals Assembly Tool into the lever
body and align the keyslot of the tool with the piston sleeve. Use the
tool to unthread the sleeve, then remove the sleeve and coupler from
the lever body.
If the piston sleeve and coupler become stuck in the lever body after
unthreading the piston sleeve, use a pair of needle nose pliers to gen-
tly grip the piston sleeve and remove it from the lever body.
6 Remove the sleeve from the coupler from the SRAM tool, then separate
the sleeve and coupler by hand.
Spray isopropyl alcohol on both the sleeve and the coupler and clean
them with a shop towel.
SwingLink bushings
SRAM Guide Lever Internals Assembly Tool
SRAM Guide Lever Internals Assembly Tool
Sleeve and coupler
Piston Assembly Removal 20