Table of Contents
Advertisement
Removing the micro SD card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Steps
1
Locate the SD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot.
2
Hold the SD card and remove it from the slot.
NOTE:
Temporarily label each SD card with its corresponding slot number after removal.
Next steps
Install a micro SD card.
Related links
Installing the micro SD card
Installing the micro SD card
Prerequisites
Follow the safety guidelines listed in
NOTE:
To use an SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
Re-install the micro SD cards into the same slots based on the labels you had marked on the cards during removal.
Steps
1
Locate the SD card connector on the internal dual SD module. Orient the SD card appropriately and insert the contact-pin end of the
card into the slot.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2
Press the card into the card slot to lock it into place.
Next steps
Follow the procedure listed in
Removing the optional IDSDM/vFlash card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If applicable, remove the full-height PCIe card.
4
If you are replacing the IDSDM/vFlash card, remove the micro SD cards.
NOTE:
Temporarily label each micro SD card with its corresponding slot number after removal.
Steps
1
Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash, see the System board jumpers and connectors section.
2
Holding the pull tab, lift the IDSDM/vFlash card out of the system.
Safety
instructions.
Before working inside your
Safety
instructions.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
system.
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
125
Advertisement
Table of Contents
