Table of Contents
Advertisement
Figure 66. Installing expansion card riser 1
Next steps
1
If removed, install expansion cards into the riser.
2
Follow the procedure listed in
3
Install any device drivers required for the card as described in the documentation for the card.
Related links
Installing expansion card into expansion card riser
Removing expansion card riser 2
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
4
If installed, remove expansion cards installed on the riser.
5
Remove the air shroud.
6
Disconnect any cables connected to the riser.
Steps
1
To remove expansion card riser 2A:
a
Using Phillips #2 screwdriver, loosen the screws that secure the riser to the system.
b Press the release tab, and holding the riser by its edges, lift the riser from the riser connector on the system board.
118
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
