Dell EMC PowerEdge R740 Installation And Service Manual page 156

Rack
Table of Contents

Advertisement

Figure 104. Installing system board
Next steps
1
Install the Trusted Platform Module (TPM).
NOTE:
The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module will be provided for all system board replacements where a TPM plug-in module was installed.
2
Replace the following:
a
Integrated storage controller card
b
Internal USB key (if applicable)
c
USB 3.0 module (if applicable)
d
iDSDM/vFlash card
e
All expansion card risers
f
Processor and heat sink module
g
Processor and DIMM blank
h
Memory modules and memory module blanks
i
Network daughter card
j
Cooling fan assembly
k
Air shroud
l
Power supply unit(s)
3
Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4
Follow the procedure listed in
5
Ensure that you:
a
Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy restore section.
b
If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see the
Entering the Service Tag section.
c
Update the BIOS and iDRAC versions.
d
Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the Trusted Platform Module (TPM)
section.
6
Import your new or existing iDRAC Enterprise license.
For more information, see Integrated Dell Remote Access Controller User's Guide, at Dell.com/esmmanuals.
156
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
After working inside your
system.

Advertisement

Table of Contents
loading

Table of Contents