Table of Contents
Advertisement
Steps
1
To install expansion card riser 2A:
a
Align the screw and tab on the riser with the screw hole and slot on the system.
b Lower the riser into the system until the riser connector engages with the connector on the system board.
c
Using Phillips #2 screwdriver, tighten the screws to secure the riser to the system.
Figure 69. Installing expansion card riser 2A
2
To install expansion card riser 2B or 2C:
a
Align the slot on the riser with the standoff on the system.
b Lower the riser into the system until the riser card connector engages with the connector on the system board.
Figure 70. Installing expansion card riser 2
Next steps
1
Install the air shroud.
2
If removed, install the expansion cards into the riser.
120
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
Advertisement
Table of Contents
