Table of Contents
Advertisement
Figure 33. Removing the NVDIMM-N battery from the air shroud
Next steps
Install the NVDIMM-N battery into the air shroud.
Related links
Installing NVDIMM-N battery into air shroud
Installing NVDIMM-N battery into air shroud
Prerequisites
1
Follow the safety guidelines listed in
CAUTION:
that your system, LEDs on system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery are turned off before
installing the NVDIMM-N battery.
CAUTION:
removing a battery.
Steps
1
Incline the NVDIMM-N battery at an angle and place the battery on the air shroud slot.
2
Using Phillips #2 screwdriver, tighten the screw to secure the NVDIMM-N battery.
3
Connect the cables to the NVDIMM-N battery.
Safety
instructions.
NVDIMM-N battery is not hot swappable. To prevent data loss and potential damage to your system, ensure
To avoid damage to the battery connector, you must firmly support the connector while installing or
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
83
Advertisement
Table of Contents
