Table of Contents
Advertisement
• To clean metal surfaces, use a usual
cleaning agent.
• Clean the appliance interior after each
use. Then you can remove dirt more
easily and it does not burn on.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all accessories after each use
and let them dry. Use a soft cloth with
warm water and a cleaning agent.
• If you have nonstick accessories, do
not clean them using aggressive
agents, sharp-edged objects or a dish-
washer. It can cause damage to the
nonstick coating.
12.1 Steam Cleaning
1.
Remove as much dirt as possible
manually.
CAUTION!
For a better performance you
should start the Steam Cleaning
function when the appliance is
cool. Check the residual heat.
Remove the shelf support to clean
the side walls.
2.
Put 400 ml of water mixed with 3 ta-
blespoons of vinegar directly into the
steam generator.
3.
Activate the Steam Cleaning function
in the main menu. The duration of the
function is approximately 33 minutes.
4.
An acoustic signal sounds when the
programme is completed. Touch the
sensor field to deactivate the signal.
5.
Wipe the internal surface of the appli-
ance with a soft sponge. You can use
warm water from the steam genera-
tor.
Do not use the sponge provided
with the appliance.
6.
Remove the remaining water from the
steam generator.
7.
After cleaning keep the appliance
door open for approximately 1 hour.
Wait until the appliance is dry.
You can get maximum effects of
the Steam Cleaning function if you
manually clean the appliance im-
mediately after the Steam Clean-
ing function ends.
When the Steam Cleaning func-
tion is active, the lamp is off.
Always use the Steam Cleaning
function after cooking with steam.
Use the Steam Cleaning function
two times if the level of dirt is high.
Make sure that the appliance is
cool before you activate the sec-
ond cycle.
12.2 Shelf supports
You can remove the shelf supports to
clean the side walls.
Removing the shelf supports
1
2
1.
Carefully pull the supports up and out
of the front catch.
2.
Lightly move the supports on the front
catch inwards.
3.
Pull the supports out of the rear
catch.
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
12.3 Decalcification of the
Steam generator
1.
Put 250 ml of water mixed with 3 ta-
blespoons of vinegar directly into the
steam generator.
2.
Activate the Decalcification function in
the Assisted Cleaning menu. The dis-
play will show the duration of the
function.
ENGLISH
47
3
Advertisement
Table of Contents
