Measure Set; Changing The Measure Set - Epson SF-180 User Manual

User Manual

Measure set.

Allows you to change the measurement settings.

Changing the Measure set.

c
Important:
❏ When performing GPS positioning, make
sure the screen is facing up and you are
outside with no obstructions overhead.
U
"Specifying a GPS (GPS Positioning)" on
page 30
❏ It usually takes less than two minutes to
complete GPS positioning.
If it takes more than two minutes and Failed
is displayed, we recommend selecting
Cancel, moving to a different location, and
trying again.
Operation buttons
A
Display the measurement screen.
Use one of the following methods to display.
❏ When performing GPS positioning:
Press C on the time screen.
❏ When skipping GPS positioning:
Press C on the time screen, and then select
Skip on the GPS positioning screen.
U
"Skipping GPS positioning" on
page 31
❏ When not performing GPS positioning
(indoor mode):
Hold down C on the time screen.
Settings
U
"Indoor mode" on page 32
B
Display the Measure set. menu.
Hold down B on the measurement screen.
C
Select a setting item.
Use C/D to select, and then press A.
D
Select a setting value.
Use C/D to select, and then press A.
Depending on the setting item, you may need to
make further settings. Follow the on-screen
instructions.
Note:
When setting a number, hold down C/D to speed
through the numbers.
E
Complete the settings.
Hold down A.
96