Measuring - Epson SF-180 User Manual

User Manual

Measuring

c
Important:
❏ When performing GPS positioning, make
sure the screen is facing up and you are
outside with no obstructions overhead.
U
"Specifying a GPS (GPS Positioning)" on
page 30
❏ It usually takes less than two minutes to
complete GPS positioning.
If it takes more than two minutes and Failed
is displayed, we recommend selecting
Cancel, moving to a different location, and
trying again.
Operation buttons
A
Display the measurement screen.
Press C on the time screen.
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
Measure
Note:
❏ You can skip GPS positioning if you want to
start measuring immediately or if it is taking
too long.
U
"Skipping GPS positioning" on page 31
❏ Use indoor mode when GPS positioning
cannot be performed because you are indoors
and so on.
U
"Indoor mode" on page 32
❏ Screens are explained using the default
screens. You can invert the screen's
monochrome display.
U
"Sys. Settings" on page 102
B
Start measuring.
Press C.
C
Record the lap.
Press D while measuring.
The Lap Hold Screen* is displayed for 5 seconds,
and then the measurement screen is displayed.
U
"Lap Hold Screen" on page 42
* The screen display differs depending on the
settings.
U
"Screen Pattern Table" on page 105
39