Table of Contents
Advertisement
User Manual
Recording Laps
Automatically (AT Lap
Function)
When a time or distance set in advance is reached, laps
are recorded automatically.
Set the lap time or distance. You can set five times or
distances. However, only one setting can be used while
measuring.
Note:
By using the PC application (Run Connect), you can setup
AT Lap from your computer.
When setting up from your computer, you can set your
own time or distance to divide laps.
U
"Setting the AT Lap Function" on page 86
c
Important:
❏ When performing GPS positioning, make
sure the screen is facing up and you are
outside with no obstructions overhead.
U
"Specifying a GPS (GPS Positioning)" on
page 30
❏ It usually takes less than two minutes to
complete GPS positioning.
If it takes more than two minutes and Failed
is displayed, we recommend selecting
Cancel, moving to a different location, and
trying again.
Measure
Operation buttons
A
Display the measurement screen.
Press C on the time screen.
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
Note:
❏ You can skip GPS positioning if you want to
start measuring immediately or if it is taking
too long.
U
"Skipping GPS positioning" on page 31
❏ Use indoor mode when GPS positioning
cannot be performed because you are indoors
and so on.
U
"Indoor mode" on page 32
B
Displays the Measure set. menu.
Hold down B on the measurement screen.
56
Advertisement
Table of Contents
