RGBlink VSP 737 User Manual page 84

Upgrade of Communication Firmware
Power off the device， take the two coding switches of downloading IP board
to ―ON‖ state as below:
Connect one side of the RJ11 download line to the RS232 controlling port,
and the other side being connected to the serial port on the PC.
Click twice to go into Flash Magic function, settings are as
below:
Firstly, choose the right serial port, set the Baud rate to 115200, choose
LPC2368, and load the aiming document (hex. file) of 100M IP board
upgrade software;
Secondly, tick the item below to confirm.
Finally, click the ―start‖ button.
VSP 737 User Manual 84