Displaying And Maintaining Traffic Policing, Gts, And Line Rate; Traffic Policing Configuration Example; Network Requirements - HPE 3100 v2 Series Configuration Manual

3. Configure the line
rate for the interface
or port group.
Displaying and maintaining traffic policing, GTS,
and line rate
On the HPE 3100 v2 Switch Series, you can configure traffic policing in MQC approach. For more
information about the displaying and maintaining commands, see
policies."
Task
Display interface GTS
configuration information.
Display interface line rate
configuration information.

Traffic policing configuration example

IMPORTANT:
This example is available only on the HPE 3100 v2 EI switches.

Network requirements

As shown in
•
Ethernet 1/0/3 of Device A is connected to Ethernet1/0/1 of Device B.
•
Server, Host A, and Host B can access the Internet through Device A and Device B.
Perform traffic control on Ethernet 1/0/1 of Device A for traffic received from Server and Host A,
respectively, to satisfy the following requirements:
•
Limit the rate of traffic from Server to 1024 kbps: transmit the conforming traffic normally, and
mark the excess traffic with DSCP value 0 and then transmit the traffic.
•
Limit the rate of traffic from Host A to 256 kbps: transmit the conforming traffic normally, and
drop the excess traffic.
Perform traffic control on Ethernet 1/0/1 and Ethernet 1/0/2 of Device B to satisfy the following
requirements:
•
Limit the total incoming traffic rate of Ethernet 1/0/1 to 2048 kbps, and drop the excess traffic.
qos lr { inbound |
outbound } cir
committed-information-rate
[ cbs committed-burst-size ]
Command
display qos gts interface [ interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
display qos lr interface [ interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
Figure 13:
N/A
40
"Displaying and maintaining QoS
Remarks
Available in any
view
Available in any
view