Table of Contents
Advertisement
Step
1.
Enter system
view.
2.
Create an
Ethernet frame
header ACL
and enter its
view.
3.
Configure a
description for
the Ethernet
frame header
ACL.
4.
Set the rule
numbering
step.
5.
Create or edit
a rule.
6.
Add or edit a
rule comment.
7.
Add or edit a
rule range
remark.
8.
Enable
counting ACL
rule matches
performed in
hardware.
Copying an ACL
You can create an ACL by copying an existing ACL (source ACL). The new ACL (destination ACL)
has the same properties and content as the source ACL, but not the same ACL number and name.
To successfully copy an ACL, make sure that:
•
The destination ACL number is from the same category as the source ACL number.
•
The source ACL already exists but the destination ACL does not.
Copying an IPv4 ACL
Command
system-view
acl number acl-number
[ name acl-name ]
[ match-order { auto |
config } ]
description text
step step-value
rule [ rule-id ] { deny |
permit } [ cos vlan-pri |
counting | dest-mac
dest-addr dest-mask | { lsap
lsap-type lsap-type-mask |
type protocol-type
protocol-type-mask } |
source-mac sour-addr
source-mask | time-range
time-range-name ] *
rule rule-id comment text
rule [ rule-id ] remark text
hardware-count enable
Remarks
N/A
By default, no ACL exists.
Ethernet frame header ACLs are numbered in the
range of 4000 to 4999.
You can use the acl name acl-name command to
enter the view of a named Ethernet frame header
ACL.
Optional.
By default, an Ethernet frame header ACL has no
ACL description.
Optional.
The default setting is 5.
,
By default
an Ethernet frame header ACL does not
contain any rule.
The lsap keyword is not supported if the ACL is for
QoS traffic classification.
Optional.
By default, no rule comments are configured.
Optional.
By default, no rule range remarks are configured.
Optional.
Disabled by default.
This command is available only on the HPE 3100 v2
EI switches.
This command takes effect only for an ACL used for
packet filtering. Do not configure this command for an
ACL used for other purposes.
9
Advertisement
Table of Contents
