Label Design Requirements; Print Requirements - Rimage Professional 3400 User Manual

Hide thumbs Also See for Professional 3400:

Table of Contents

Rimage Professional 3400 and 5400N User Guide

Label Design Requirements

The Rimage Windows-compati ble soft ware ships with the CD Designer™ label editor. CD Designer is installed on the

embedded or non-embedded PC during a typical installati on of the Rimage soft ware and is used for designing labels for

printi ng with the integrated Everest 400 printer. CD Designer can be used to design labels on any Windows-based PC.

•

Label design size – Design labels with a height of 12 cm and width of 12 cm. A full-size disc is 120 mm (4.723") in

diameter. The hole is 15 mm (0.59") The printable area and hub sizes vary depending on the disc manufacturer.



Note: The media that are in Rimage Media Kits have a printable area of 118-24 mm. On most labels, print setti ngs

of 118 mm and 24 mm are recommended.

Printable

Area 118 mm

•

File format – For best results, save your labels as JPEG or TIFF ﬁ les. However, these ﬁ le formats must be imported into

CD Designer and saved as CD Designer ﬁ les (.btw) or converted to PDF ﬁ les before printi ng.

•

Color mode – Convert all labels to the RGB color mode in order to import them into CD Designer.

•

Resoluti on (pixels per inch) – For best results, use images set to a minimum of 300 pixels per inch. You may noti ce

bett er results if you use images with 600 pixels per inch or higher.

Any label you create and save through CD Designer is in the correct ﬁ le format (.btw) for printi ng to the integrated Everest

400 in the 3400 and 5400N system. You can also print labels saved as PDF ﬁ les.

Hub Size

24 mm

2001431_A

Table of Contents

Professional 5400n