Everest 600 Printer Requirements; Ribbon Requirements; Label Design Requirements; Everest 600 Ribbons - Rimage Everest 600 User Manual

Everest 600 Printer Requirements

This section describes ribbon, label design, and print requirements for the
Everest 600 printer.

Ribbon Requirements

Important!
Rimage only supports the use of Rimage brand ribbons in our printers.
•
Printer issues that occur as a result of using ribbons from manufacturers
other than Rimage are not included under your Rimage warranty or
maintenance agreement.
For optimum results, make sure that Everest 600 ribbons are stored at a
•
temperature between 41° and 95°F
(5° to 35°C) and humidity level between 45% and 85%.
Avoid moisture and direct sunlight.
•
Do not reuse ribbons.
•
Use only ribbons designed for the Everest 600 printer. Refer to the table
•
below.
The Everest 600 printer requires a print ribbon and a retransfer ribbon. The
standard print ribbon has three colors: Cyan, Magenta, and Yellow (CMY).
These three colors combine in printing to create full-color discs. Print
ribbons are also available in black.

Everest 600 Ribbons

Ribbon Type
3-Color (CMY)
Black (monochrome)
Retransfer ribbon (500 prints)
2001474_B
Number of Discs Printed
500
1000
500
For more information visit

Label Design Requirements

The Everest 600 Windows-compatible software ships with the CD Designer™
label editor software. This software is installed on your PC during a typical
installation of the Rimage software. If you have a Windows-based PC, you
can use CD Designer to design your labels.
If you are using a Macintosh, or prefer to design labels in a software
application other than CD Designer, use the following criteria.
Important! CD Designer is not Macintosh-compatible and is not installed
with the Macintosh-compatible Rimage software.
• Label design size – Design labels with a height of 12 cm and width of 12
cm. A full-size disc is 120 mm (4.723") in diameter. The hole is 15 mm
(0.59"). The printable area and hub sizes vary depending on the disc
manufacturer.
Tip: The media that are in Rimage Media Kits have a printable area of
118-24 mm. On most labels, print settings of 118 mm and 24 mm are
recommended.
Printable
Area 118 mm
rimage.com/support
Hub Size
24 mm
5