Personal Recipient Messages; Hard Wired Input/Output Connection - Tunstall Caresse Installation And Programming Manual

Personal recipient messages

Recording a personal recipient message
A personal recipient message can be recorded on the Caresse to replace the ID
message that a personal recipient would normally hear when they receive an alarm call.
To record a message, press:
Note: if a message is already recorded, this key sequence will replay the message. If this
is the case the message must be deleted before a new message can be recorded.
To delete a message, press:
Dealing with personal recipient calls from a touch-tone telephone
Alarm calls can be sent to personal recipients, when a personal recipient receives an
alarm call they will hear a spoken message (Unit ID or recorded message). The recipient
can then handle the call using their keypad as follows:
Function
Accept Call
Clear Call
Volume up
Volume down
Talk
Listen

Hard wired input/output connection

Input - devices can be hard wired to the Caresse using pins 1 and 8 of
the AUX jack.
Output – alternatively the Caresse can be connected to other devices
e.g. Buzzers using pins 3 and 4 of the AUX jack. PC Connect should be
used to configure which events should activate the output. This is done
by entering event configuration and setting the relay behavior. It is
recommended that a second event should be set to perform the opposite
function e.g. alarm event turns relay on, cancel button turns relay off.
A cord with an RJ45 plug will need to be provided.
NOTE: Hard wired input devices must be assigned as either a smoke detector or pull cord via the PC
Connect programming tool or monitoring center.
Button Notes
5
* then # Call must be accepted first
1
Alters Caresse volume
2
7 Only required if mode is changed from Hands-free
Voice Switched (HVS) to tone switched by pressing
*
7 followed by *.
Page 30 of 40
Record the message
Pin 1 Pin 8