Pendants And Telecare Sensors - Tunstall Caresse Installation And Programming Manual

Pendants and telecare sensors

Each Caresse can be easily programmed to receive up to 15 (35 for the Caresse+)
pendants and telecare sensors, this can be done by pressing:
then activate the pendant/sensor.
If successful, the Caresse will announce the name of the pendant/sensor programmed. If
unsuccessful, a low pitched tone will be heard (e.g. particular pendant/sensor already
programmed or maximum number of pendants/sensors already programmed).
NOTE: Location codes and individual settings, e.g. setting a PIR as entry/exit, must be done via the PC
Connect programming tool or the monitoring center.
To erase one pendant/sensor, press:
then activate the pendant/sensor to be deleted.
To erase all pendants/sensors, press:
Walk/Range test for pendants/sensors
The range of all programmed pendants/sensors can be tested without actually raising an
alarm call to an alarm recipient. The range of the pendant must always be tested
immediately after installation to ensure correct operation. These tests should be
performed at floor level around the dwelling to confirm coverage. To put the Caresse into
walk/range test mode, press:
Then press the pendant.
Each time the pendant is pressed, the Caresse will bleep to indicate the pendant has
made contact with the Caresse. The Caresse will automatically exit walk/range test
mode after 3 minutes or when the green cancel key is pressed.
NOTE: If the unit is already wall mounted the range test mode can be accessed by pressing and holding the
green cancel button for 5 seconds, the unit will announce 'Walk Test Mode'.
Page 20 of 40