Programming The Caresse; Programming Keypad - Tunstall Caresse Installation And Programming Manual

Programming the Caresse

Programming of the Caresse and its functions can be achieved using three different
methods:
Programming Keypad - Basic programming can be achieved by using the
•
programming keypad on the underside of the Caresse. This includes a simplified
way of programming telephone numbers, call codes and the turning on/off of
functions of the Caresse. Instructions are included within this programming guide.
Tunstall PNC4 and CMS 4000 – this method allows more in depth remote
•
programming at the monitoring center using custom designed screens within the
PNC software (depending upon the software version) or via manual entry of
parameters.
PC Connect Programming Tool - Full programming can be achieved using the
•
PC Connect programming tool on a PC linked to the Caresse.

Programming keypad

All programming begins and ends with
the monitoring center.
Explanation
In the following instructions the below keys have the following meanings:
This button press can be 1, 2, 3 or 4 depending upon the position of the
number required to program. For example to program monitoring center
number 2, press 2 when this key is shown.
Monitoring center number 1 (2, 3 and 4 also used)
Personal Recipient number 1 (2 and 3 also used)
Information monitoring center number 1 (2 also used)
NOTE: All programming not listed in this guide must be completed using the PC Connect programming tool
or via the monitoring center.
except for programming of the test alarm to
Each time a key is pressed a tone is
sounded indicating that the press is
approved. After each programming
sequence a tone is sounded indicating the
following:
Successful programming = 3 tones
Unsuccessful programming = 1 tone
Page 12 of 40