Call Sequences - Tunstall Caresse Installation And Programming Manual

Call sequences

As it is not possible to program call sequences using the keypad, default call sequences
are used which depend on the mixture of monitoring center, personal recipient and
information numbers programmed into the Caresse. The default call sequences are as
follows:
Only monitoring center numbers programmed
When an alarm is raised, the Caresse firstly calls alarm number 1 twice and thereafter
calls alarm numbers 2, 3 and 4 once each. If there is no answer from any of the four
numbers, the Caresse calls alarm number 1 again, but this time four times, and then
calls the next alarm number etc until the alarm is received. The maximum number of call
attempts is 10 therefore the call sequence used is as follows:
x2 x1 x1
Only personal recipient numbers 1-3 programmed
The following call sequence is used:
x1 x1 x1
Both monitoring center and personal recipient numbers 1-3 programmed
The following call sequence is used:
x1 x1 x1
Information monitoring center number 1 programmed
The following call sequence is used:
repeated 15 times
Information monitoring center number 2 programmed
The following call sequence is used:
x5 x2 x1
x1 x4 x4
x4 x4 x4
x2 x1 x1
x1 x1 x1
Page 18 of 40
x4 x4 x8
x4 x4 x4
x8 x8
x1 x1 x1
x8
x1