Critical Visits (Caresse+ Only) - Tunstall Caresse Installation And Programming Manual

Critical visits (Caresse+ only)

Critical visit monitoring allows scheduled care giver visits to users to be monitored and
enables alarms to be raised if the schedule is not met. The Caresse allows up to six daily
care giver visits to be monitored. Each care giver visit is defined by a visit time and a
time window (centered on the visit time), which is an acceptable time window for the visit
to occur. The default time window is 60 minutes i.e. the visit should occur between 30
minutes before and 30 minutes after the set visit time. During the time window, the
Caresse must receive a transmission from a carer trigger otherwise a Carer Non-Arrival
alarm will be generated.
To set a critical visit time, press:
(1-6) = Critical visit time slots 1 – 6
The above turns critical visit monitoring on at HHMM with a time window of 60 minutes.
To set a critical visit time and window, press:
XX = 00-99 minutes (00 sets default value of 60 minutes)
To erase a critical visit time, press:
To erase all critical visit times, press:
NOTE: Using the PC Connect programming tool any pendant can be defined as a Carer Trigger.
HHMM
HHMM
Page 29 of 40