Unit Id Number - Tunstall Caresse Installation And Programming Manual

Unit ID number

The Caresse sends a unit ID number to the alarm receiver when an alarm is sent. The
number identifies which Caresse is sending the alarm. Unit ID number 1 must be
programmed into the Caresse in order for an alarm to be sent. The unit ID number may
be the same for all monitoring centers and personal recipients. Using the keypad, the
Caresse can be programmed with up to 4 unit IDs (10 ID numbers can be programmed
using the other programming methods) e.g. ID 1 can be used for local alarms to a
recipient in a facility and ID 2 can be used for calls to a monitoring center.
The unit ID can be programmed into the Caresse by pressing:
Unit ID (max 12 digits)
NOTE: If no unit ID is linked to an alarm receiver, the first valid code will be used. The actual number of
digits sent to the alarm receiver depends upon the type of monitoring center being used. Please contact your
monitoring center for more information.
To erase one unit ID number, press:
To erase all unit ID numbers, press:
The Unit ID number is used as follows:
If unit ID 1 is programmed it is used for
If unit ID 2 is programmed it is used for
If unit ID 3 is programmed it is used for
If unit ID 4 is programmed it is used for
NOTE: If no unit ID is linked to an alarm receiver, the first valid code will be used.
Page 19 of 40