Adjusting The Speaker Volume; No Fault Report Window; Language Selection - Tunstall Caresse Installation And Programming Manual

Adjusting the speaker volume

The Caresse has four volume level settings, which can be adjusted as follows.
To increase volume, press:
Tone sounds for 10 seconds. Press repeatedly until volume is reached.
Then press before the tone ends to save the new volume setting.
To decrease volume, press:
As above but use instead of

No fault report window

The speech announcements of fault conditions such as AC power failure can be turned
off during specific time periods e.g. at night. The daily start and end times can be set as
follows.
To set the start time, press:
HHMM
To set the end time, press:
HHMM
The time must be entered in 24 hour format. Please allow 24 hours after setting the
feature for it to become active.

Language selection

The home unit is pre-programmed with three language choices (English, French and
Spanish) for speech announcements. The language can be altered as follows:
X
X represents the language to be used (2 = French, 4 = English, 7 = Spanish)
Page 14 of 40