Terminal Pin Assignment; Overview Of Terminal Pin Assignment (Outside Box) - Furuno FA-150 Installation Manual

3.2.

Terminal pin assignment

3.2.1. Overview of terminal pin assignment (Outside box)

Figure 2: Mounting of the migcplex8 GIC Pro
Table 2: Overview of terminal pin assignment
1 PC output RS232(for configuration and readout of data)
2 RJ45 network connector
3 USB connector for firmwire update
NOTE: For authorised technical staff only
4 Status LED (See point 3.2.1.1)
5 Reset button (See point 3.2.1.2)
3.2.1.1. Status LED
The status LED indicates the magicplex8 GIC Pro's readiness for operation when it blinks.
Whenever the magiplex8 GIC Pro is supplied with power a selfcheck and hardware test starts.
NOTE: This operation takes 20seconds.
- The status Led starts to blink only 20seconds after the magicplex8 GIC Pro is supplied
with power.
- If the status LED does not blink after 20seconds, there is a technical problem!
3.2.1.2. Reset button
The system is restated when you press the reset – button (See point 3.2.1.2)
U
lstein Power & Control AS
This document and its content is the property of ULSTEIN. Non-
public information contained herein shall be treated as
Confidential Information. No use, copying, citation or publication
of this document or its content is permitted without prior written
consent from ULSTEIN. Any conflicts arising from unauthorized
use shall be governed by the laws of Norway.
File Name: Page:
Page 16 of
BRI-D32004-01II (D)
System Installation 56
Manual.doc