Furuno FA-150 Installation Manual page 117

Figure 11: Command line interpreter with ping statistics
Installing the USB Driver
2.2.2.4
The "WAGO USB Service Cable" (Item No.: 750-923) provides easy communication with the
WAGO software tools (WAGO-ETHERNET-Settings, WAGO-I/O-CHECK 3, etc.) and with the
IEC-61131 programming topology (WAGO-I/O-PRO).
Proceed as follows to install the USB driver:
I. Start the network browser and open the web page www.wago.com. You can
dowload the USB Driver under: Service -> Downloads -> AUTOMATION ->
WAGO-I/O-SYSTEM 750/753 -> 759-923.
II. After download start installation.
Figure 12: Selecting the target directory
III. As soon as the installation is completed successfully, finish the Setup by clicking
the button [OK].
U
lstein Power & Control AS
This document and its content is the property of ULSTEIN. Non-
public information contained herein shall be treated as
Confidential Information. No use, copying, citation or publication
of this document or its content is permitted without prior written
consent from ULSTEIN. Any conflicts arising from unauthorized
use shall be governed by the laws of Norway.
File Name: Page:
Page 45 of
BRI-D32004-01II (D)
System Installation 56
Manual.doc