Furuno FA-150 Installation Manual page 123

II. In the "Communication Parameters" dialog, click the [NEW...] button to create a
new communication channel. The "Communication Parameters: New Channel"
dialog appears.
Figure 22: Communication Parameters, Create communication channel
III. For an ETHERNET connection, assign a name to the communication channel you
just created in the Name input box (here "ETHERNETConnection" as an
example).
IV. Then select the driver "Tcp/Ip 3S Tcp/Ip driver."
V. Click [OK] to confirm your entries.
Figure 23: Communication Parameters, New channel
VI. Then double-click on the localhost address field in the Value column in the
"Communication Parameters" dialog for this communication channel.
VII. Enter the IP address of your PLC here (192.168.1.100). You can leave all other
parameters (Port, Motorola byteorder, and the gateway settings) as they are.
U
lstein Power & Control AS
This document and its content is the property of ULSTEIN. Non-
public information contained herein shall be treated as
Confidential Information. No use, copying, citation or publication
of this document or its content is permitted without prior written
consent from ULSTEIN. Any conflicts arising from unauthorized
use shall be governed by the laws of Norway.
File Name: Page:
Page 51 of
BRI-D32004-01II (D)
System Installation 56
Manual.doc