Tpd-280-Mx/283-Mx/283U-Mx Series Models - ICP DAS USA TPD-280 User Manual

TPD/VPD Series HMI Device User Manual

2.1.2 TPD-280-Mx/283-Mx/283U-Mx Series Models

Models supported include TPD-280-M1, TPD-280-M2, TPD-280-M3, TPD-283-M1, TPD-283-M2,
TPD-283-M3, TPD-283U-M1, TPD-283U-M2 and TPD-283U-M3.

1. 2.8" TFT LCD with Touch Panel
2. Power/GND/RS-485 Connector
The TouchPAD device is equipped with a removable terminal block connector is
designed for easy and robust wiring. For more detailed information regarding the pin
assignments, refer to
3. PoE and Ethernet RJ-45 Jack
The TouchPAD device is equipped with an RJ-45 jack that is used as the 10/100 Base-TX
Ethernet port and features networking capabilities.
detected and an Ethernet packet is received, the Act LED (Green) indicator will be
illuminated. When power is supplied via PoE (Power-over-Ethernet), the PoE LED
(Orange) indicator will be illuminated.
4. Rotary Switch (0 ~ 9)
The Rotary Switch is used to set the configuration modes, as follows:

For TPD-280-M1/M2/M3:
0. Run Only: This mode is used for running programs.
1. Update Only: This mode is used for updating programs.
Copyright © 2017 ICP DAS Co., Ltd. All Rights Reserved.

(The TPD-283-Mx does not support this connector)
Section 2.2.1 TPD-280/283/430/433 Series
(The TPD-280-Mx does not support this jack)


Models.
When an Ethernet link is
Page: 25