Schedule Configuration Example - HP 5130 EI series Configuration Manual

Step
8. Specify an execution
time table for the
periodic schedule.

Schedule configuration example

Network requirements
As shown in
To save energy, configure the device to perform the following tasks:
Enable interfaces GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 at 8:00 a.m. every Monday
•
through Friday.
• Disable the interfaces at 18:00 every Monday through Friday.
Figure 39 Network diagram
Scheduling procedure
# Enter system view.
<Sysname> system-view
# Configure a job for disabling interface GigabitEthernet 1/0/1.
[Sysname] scheduler job shutdown-GigabitEthernet1/0/1
[Sysname-job-shutdown-GigabitEthernet1/0/1] command 1 system-view
[Sysname-job-shutdown-GigabitEthernet1/0/1] command 2 interface gigabitethernet 1/0/1
[Sysname-job-shutdown-GigabitEthernet1/0/1] command 3 shutdown
[Sysname-job-shutdown-GigabitEthernet1/0/1] quit
# Configure a job for enabling interface GigabitEthernet 1/0/1.
[Sysname] scheduler job start-GigabitEthernet1/0/1
Command
•
Execute the schedule at an interval
from the specified time on:
time repeating at time
[ month-date [ month-day | last ] |
week-day week-day&<1-7> ]
•
Execute the schedule at the
specified time on every specified
day in a month or week:
time repeating [ at time [date ] ]
interval interval-time
Figure 39, two interfaces of the device are connected to users.
118
Remarks
Configure either command.
By default, no execution time is
specified for a schedule.
Executing commands clock
datetime, clock summer-time, and
clock timezone does not change the
execution time table that is already
configured for a schedule.