Using The Device To Log In To An Ssh Server; Logging In Through A Pair Of Modems - HP 5130 EI series Configuration Manual

Using the device to log in to an SSH server

You can use the device as an SSH client to log in to an SSH server. If the server is located in a different
subnet than the device, make sure the two devices have routes to reach each other.
Figure 13 Logging in to an SSH client from the device
Perform the following tasks in user view:
Task
Log in to an IPv4 SSH server.
Log in to an IPv6 SSH server.
To work with the SSH server, you might need to configure the SSH client. For information about
configuring the SSH client, see Security Configuration Guide.

Logging in through a pair of modems

You can use a pair of modems to remotely connect to the console port of the device over PSTN when the
IP network connection is broken.
By default, modem dial-in is enabled, and you can dial in to the switch. The default user role is
network-admin. To change modem dial-in parameters, see
To use a pair of modems to remotely log in to the device:
1. Connect one modem to the serial port of the PC and another modem to the console port of the
device.
2. Connect each modem to the PSTN through a telephone cable.
Figure 14 Connecting the PC to the device through modems
3. Obtain the telephone number of the device-side modem.
4. Configure the following settings on the device-side modem:
AT&F—Restores the factory default.
ATS0=1—Configures auto-answer on first ring.
AT&D—Ignores DTR signals.
AT&K0—Disables local flow control.
AT&R1—Ignores RTS signals.
AT&S0—Forces DSR to remain on.
Command
ssh2 server
ssh2 ipv6 server
"Logging in through the console port
33
locally."