HP 5130 EI series Configuration Manual page 35

To use local authentication, configure a local user and the relevant attributes.
•
For more information, see Security Configuration Guide.
The next time you Telnet to the CLI, you must provide the configured login username and password, as
shown in Figure 1
the message "All lines are used, please try later!" appears.
Figure 11 Scheme authentication interface for Telnet login
Setting the maximum number of concurrent Telnet users
Step
1. Enter system view.
2. Set the maximum number
of concurrent Telnet users.
Setting the DSCP value for outgoing Telnet packets
The DSCP value is carried in the ToS/Traffic class field of an IP or IPv6 packet, and it indicates the
transmission priority of the packet.
To set the DSCP value for outgoing Telnet packets:
Step
1. Enter system view.
2. Set the DSCP value for
outgoing Telnet
packets.
1. If the maximum number of login users has been reached, your login attempt fails and
Command
system-view
aaa session-limit telnet
max-sessions
Command
system-view
•
For a Telnet server running IPv4:
telnet server dscp dscp-value
•
For a Telnet server running IPv6:
telnet server ipv6 dscp dscp-value
Remarks
N/A
By default, the maximum number of concurrent
Telnet users is 32.
Changing this setting does not affect online
users. If the current number of online Telnet users
is equal to or greater than the new setting, no
additional Telnet users can log in until online
users log out.
For more information about this command, see
Security Command Reference.
28
Remarks
N/A
By default, the DSCP value is 48.