HP 5130 EI series Configuration Manual page 138

A DNS server IP address.
For more information, see
3. After getting automatic configuration parameters, the device tries to download a configuration file
from a TFTP server or an HTTP server. For more information, see
process."
4. If the device gets a configuration file, it deletes its temporary settings to restore the factory defaults
and executes the configuration file. If the device gets no configuration file or fails to execute the
configuration file, the device deletes its temporary settings and stays quiet for 30 seconds. Then,
the device tries again for automatic configuration by selecting another qualified interface and
repeating Step 2 to Step 4. To stop the automatic configuration process, press Ctrl+D at the CLI of
the device.
IMPORTANT:
To ensure quick and successful automatic configuration of a device, connect only the interface used for
•
automatic configuration to the network.
The device does not save the obtained configuration file. To use the configuration after a reboot, save the
•
running configuration by using the save command. Otherwise, the device has to perform automatic
configuration again after a reboot. For more information about the save command, see
Command Reference
"Automatic-configuration parameter acquisition
.
131
process."
"Configuration file acquisition
Fundamentals