Chapter 4: Hardware Assembly; Filament Installation - Flashforge Guinder II User Manual

Chapter 4: Hardware Assembly

Your GuiderⅡ has been installed before leaving factory, you can start up the GuiderⅡ
for printing after mounting the filament spool and completing leveling.

4.1 Filament Installation

(4-1) The filament cartridge is at the rear of GuiderⅡ. Lift the cartridge out of the
Guider Ⅱ.
(4-2) Take out the filament and thread it through the filament detecting equipment.
(Note: The filament should feeds from the bottom of the spool towards the top )
GuiderⅡ User Guide | www.flashforge.com
4-1
4-2
25
Filament Detecting
Equipment in the black.
400-699-1063