Flashforge Guinder II User Manual page 45

①Preview: Choose to enter preview interface or not
②Print when slice done: Print or not when slice done
③Material type: Choose according to the type of model
④ Supports: When print suspended structure models, support is necessary. Click
[supports] to create support part for the printing.
⑤Raft: This function will help the model to stick well on the platform.
⑥ Wall: During dual color printing, this function will help to clear the leaking
filament of another extruder.
⑦ Brim: Expand the outline of model's bottom layers to a Brim which helps anchor
the edges of the model to the plate to avoid warping.
⑧Resolution： You have three resolution solutions (with default setting)to choose from,
high resolution is corresponding with slow printing speed, opposite for the low
resolution. For PLA printing, an extra solution "Hyper" is available.
⑨ More options: Click
temperature. Different resolution solution is corresponding to different defaults, click
[Restore Defaults] to back to default setting.
●Layer
a. Layer: Layer thickness of the printing model. With a small value, the surface
of the model will be smoother.
b. First Layer Height: This is the first layer of the model, which will affect the
sticking performance between the model and platform. Maximum is 0.4mm, usually
the default is OK.
c. Shell: Contains the outside shell value, capping layer value (under vase pattern,
top solid layer setting is invalid.)
● Perimeter Shells: Maximum is 10
GuiderⅡ User Guide | www.flashforge.com
[More options] to set for layer, shell, infill, speed and
45
400-699-1063