Flashforge Guinder II User Manual page 55

shows the current actual temperature of corresponding part. After starting heating, the
below curve of temperature form will start to change, different color correspond
different parts' temperatures
② Update Firmware
Every time when you start FlashPrint, it will automatically detect and download the
up-to-date firmware. If any update is available, a dialog box will pop up for reminding
the users to update.
Step 1: Click [Tools]--[Update firmware]. It needs to cut off connection before
updating firmware. If software and printer are already in connection, it reminds you
[Yes]
cutting off the connection, and then choose and go on to the next step.
Step 2: Choose corresponding printer type and firmware version and click [OK] in the
firmware updating box. After confirming the printer is in free state, the software will
automatically update the firmware
6-24
Step 3：Reboot you Guider Ⅱ and wait for 4-5 seconds, then you can see the update
process bar. When the update finishes, it will go back to the main interface.
Step 4：Tap [Tools]--[About]
to check whether the updated version is right.
GuiderⅡ User Guide | www.flashforge.com 400-699-1063
55