Door Position Devices; Magnetic Contacts - HP POD 20c Maintenance And Service Manual

Door position devices

Magnetic contacts

Magnetic contacts are located on all doors and cabinets.
You need a screwdriver and scissors to remove and replace the magnetic contact.
Removing the magnetic contacts
Remove the two screws that secure the upper magnet (1).
1.
Cut the tie wrap (2) and loosen the nut on the POD structure that secures the wire.
2.
Pull the wire all the way through to the point of entry or ECS panel (3).
3.
Replacing the magnetic contacts
Feed the wire all the way through from the point of entry or ECS panel (1).
1.
Tighten the nut on the POD structure that secures the wire, and then replace the tie wrap (2).
2.
Secure the magnet to the bracket using two screws (3).
3.
Removal and replacement procedures 18