Hardware Identification Chart - Stamina 1764 Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers or
the ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to
check the length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws, except those with flat
heads, is measured from below the head to the end of the bolt
or screw. Flat head bolts and screws are measured from the
top of the head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
69
70
68
48
75
24
33
39
31
25
16
90
32
28
73
26
74
18
27
23
29
72
84
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Flange Nut, Brass Color (M10 x 1.25, Left Hand Threads)
Flange Nut, Black Color (M10x1.25, Right Hand Threads)
Tooth Lock Washer (M10)
Carriage Bolt (M8 x 1.25 x 65mm)
Carriage Bolt (M8 x 1.25 x 75mm)
Bolt, Button Head (M8 x 1.25 x 20mm)
Bolt, Button Head (M8 x 1.25 x 15mm)
Bolt, Button Head (M8 x 1.25 x 12mm)
Bolt, Button Head (M8 x 1.25 x 48mm)
Bolt, Hex Head (M6 x 1 x 38mm)
Screw, Round Head (M5 x 0.8 x 15mm)
Screw, Round Head (M5 x 0.8 x 55mm)
Nylock Nut (M8 x 1.25)
Acorn Nut (M6 x 1)
Acorn Nut (M8 x 1.25)
Arc Washer (M6)
Arc Washer (M8)
Lock Washer (M8)
Lock Washer (M6)
Large Washer (M8 x ø32 x 2mm thick)
Spacer Washer (ø19 x ø38 x 0.5mm thick)
Washer (M8)
Wave Washer (ø20 x ø26 x 0.5mm thick)
6
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
1
1
2
2
2
11
6
6
4
4
4
1
4
4
4
4
6
15
4
2
2
11
2