Assembly Instructions - Stamina 1764 Owner's Manual

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com under the Service section and order the part needed,
e-mail us at customerservice@staminaproducts.com, or call us toll free at 1-800-375-7520 (in the
U.S.). Our Customer Service Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central
Time) Monday through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.
STEP 1
There is an "L" decal on the FRONT STABILIZER(80). Position the FRONT STABILIZER(80) with the "L"
decal on the left side, and attach it to the MAIN FRAME(1) with CARRIAGE BOLTS(M8x1.25x75mm)(75),
ACORN NUTS(M8x1.25)(73), LOCK WASHER(M8)(18), and ARC WASHERS(M8)(74).
STEP 2
Attach the STANDS(46) to the bottom of the REAR BASE(2).
STEP 3
Make sure the grooves on the REAR BASE(2) are on top as shown. Attach the REAR BASE(2) to the
MAIN FRAME(1) with CARRIAGE BOLTS(M8x1.25x65mm)(48), ACORN NUTS(M8x1.25)(73), LOCK
WASHER(M8)(18), and ARC WASHERS(M8)(74).
NOTE: You can adjust the LEVELING CAPS(47) and the STANDS(46) on the REAR BASE(2) to keep
the 1764 Magnetic Elliptical Trainer stable.
L
7