Hardware Identification Chart - Stamina EX 30 Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers, the
end of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
94
95
96
98
101
102
103
104
106
108
109
110
113
114
116
55
118
119
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Screw, Round Head (M4 x 20mm)
Screw, Round Head (M5 x 20mm)
Screw, Round Head (M5x 0.8 x 20mm)
Bolt, Round Head (M8 x 1.25 x 16mm)
Bolt, Socket Head (M6 x 1 x 35mm)
Bolt, Socket Head (M8 x 1.25 x 16mm)
Bolt, Socket Head (M8 x 1.25 x 25mm)
Bolt, Socket Head (M8 x 1.25 x 40mm)
Bolt, Button Head (M8 x 1.25 x 16mm)
Bolt, Button Head (M8 x 1.25 x 30mm)
Bolt, Button Head (M8 x 1.25 x 90mm)
Bolt, Button Head (M10 x 1.25 x 85mm)
Nylock Nut (M6 x 1)
Nylock Nut (M8 x 1.25 x 8mm thick)
Nylock Nut (M10 x 1.25)
Large Washer
Washer (M10)
Lock Washer (M8)
5
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
4
2
2
4
4
4
2
4
4
2
4
2
4
10
2
2
2
12