Stamina 1764 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 4
Slide the UPRIGHT SLEEVE(78) over the UPRIGHT(17). Refer to illustration below. Tie the STRAP to the
hook on the end of the TENSION CABLE(89). Pull the STRAP from the square opening in the UPRIGHT(17)
until the TENSION CABLE(89) is pulled through and extends out of the square opening in the UPRIGHT(17).
Connect the CONNECTION WIRE(88) to the SENSOR WIRE(85). Slide the UPRIGHT(17) onto the MAIN
FRAME(1) and secure with BUTTON HEAD BOLTS(M8x1.25x20mm)(24), LOCK WASHERS(M8)(18),
WASHERS(M8)(72), and ARC WASHERS(M8)(74). Slide down the UPRIGHT SLEEVE(78) to cover the
bolt heads.
STEP 5
Refer to the inset drawing and detail view A to connect the TENSION KNOB(38) to the TENSION CABLE(89):
1. Set the TENSION KNOB(38) at position "6" so that the CABLE END extends out at the proper position
for assembly. Connect the CABLE END of the TENSION KNOB(38) to the HOOK on the end of the
TENSION CABLE(89).
2. Pull on the TENSION CABLE(89) firmly so that enough cable is available to allow the METAL FITTING
go through the slot in the top of the BRACKET.
3. Insert the METAL FITTING into the hole at the end of the slot in the BRACKET.
4. Adjust the TENSION KNOB(38) and verify that the HOOK moves when the TENSION KNOB(38) is
adjusted.
5. Attach the TENSION KNOB(38) to the UPRIGHT(17) with ROUND HEAD SCREW(M5x0.8x55mm)(90).
Strap
A.
8
Metal Fitting
Hook
1
Cable End
Bracket
2
3