Switches S201, S202, And S801; Final Set-Up And Test - GE AF-600 FP Operating Instructions Manual

Electrical Installation

3.3.3 Switches S201, S202, and S801

Switches S201 (A53) and S202 (A54) are used to select a
current (0-20mA) or a voltage (-10 to 10V) configuration of
the analog input terminals 53 and 54 respectively.
3 3
Switch S801 (BUS TER.) can be used to enable termination
on the RS-485 port (terminals 68 and 69).
See drawing Diagram showing all electrical terminals in
section Electrical Installation.
Default setting:
S201 (A53) = OFF (voltage input)
S202 (A54) = OFF (voltage input)
S801 (Bus termination) = OFF
NOTE
When changing the function of S201, S202 or S801 be
careful not to use force for the switch over. It is
recommended to remove the keypad fixture (cradle) when
operating the switches. The switches must not be operated
with power on the frequency converter.

3.4 Final Set-up and Test

To test the set-up and ensure that the frequency converter
is running, follow these steps.
Step 1. Locate the motor name plate
NOTE
The motor is either star- (Y) or delta- connected (Δ). This
information is located on the motor name plate data.
38
AF-600 FP High Power Operating Instructions
Step 2. Enter the motor name plate data in this parameter
list.
To access this list first press the [QUICK MENU] key then
select "Quick Setup". Use the up and down arrow keys to
navigate to the parameters associated with the motor
nameplate values.
1.
2.
130BT310.10
3.
4.
5.
Step 3. Activate the Auto tune
Performing an auto tune will ensure optimum
performance. The auto tune measures the values from the
motor model equivalent diagram.
1.
2.
3.
4.
P-07 Motor Power [kW]
P-02 Motor Power [HP]
F-05 Motor Rated Voltage
F-04 Base Frequency
P-03 Motor Current
P-06 Base Speed
Activate the auto tune P-04 Auto Tune.
Choose between complete or reduced auto tune.
If a Sine-wave filter is mounted, run only the
reduced auto tune, or remove the Sine-wave filter
and run complete Auto Tune.
Press the [OK] key. The display shows "Press
[Hand] to start".
Press the [Hand] key. A progress bar indicates if
the auto tune is in progress.