Power Management Problems - Getac B300 User Manual

The PC card stops communicating properly.
The application may have been reset when the computer is turned off or

in Sleep mode. Exit and restart the application.

Power Management Problems

The computer does not enter Sleep or Hibernation mode
automatically.
If you have a connection to another computer, the computer does not

enter Sleep or Hibernation mode if the connection is actively in use.
Make sure that the Sleep or Hibernation time-out is enabled.

The computer does not enter Sleep or Hibernation mode
immediately.
If the computer is performing an operation, it normally waits for the

operation to finish.
The computer does not resume from Sleep or Hibernation mode.
The computer automatically enters Sleep or Hibernation mode when the

battery pack is empty. Do any one of the following:
−
Connect the AC adapter to the computer.
−
Replace the empty battery pack with a fully charged one.
The computer does not enter Hibernation mode with the Fn+F12 hot
keys.
Make sure that the Hibernation function is specified for the sleep

button.
You might be using a PC card that prevents the computer from entering

Hibernation mode. To enter the mode, stop the communication program
and then remove the card or stop the card.
8-8
Troubleshooting