Using Smart Cards - Getac B300 User Manual

Using Smart Cards

NOTE: On your computer, the Smart Card reader is a part of the super multi
drive module. If the super multi drive module is replaced by a secondary
battery pack or hard disk drive, you cannot use the Smart Card reader.
With an embedded microcontroller, smart cards have the unique ability to
store large amounts of data, carry out their own on-card functions (e.g.,
encryption and mutual authentication), and interact intelligently with a
smart card reader.
To insert a smart card:
1. Locate the smart card slot on the left of the computer and open the
cover.
2. Slide the smart card, with its label and embedded computer chip facing
up into the slot.
3. When a new card is seated, use the third-party smart card software to
allow your computer to read it.
To remove a smart card:
1. Make sure that the third-party smart card software is not accessing the
smart card.
2. Pull the card out of the slot.
Chip
Expanding Your Computer
4-9